Luxwood's appliqué are warranted to be free from manufacturing defect, for as long as the purchaser owns the vehicle. Installation warranty is the responsability of the installer. Here is the installation procedure :
IMPORTANT NOTICE :
1. Prior to installation, check the entire kit for possible damage or defect. If damage or defects are found, contact your vendor for replacement. Do not install any parts. You must return the complete kit in original packaging to make a warranty claim.
2. Please note, small surface impressions may appear on the kit due to packaging. These marks are not product defect and should disappear after heating surface and wiping clean.
3.The most common installation error is improper cleaning. This will cause tape failure, which will result in improper installation or part falling off. Follow instruction precisely.
INSTRUCTIONS:
1.Check fit and alignment
2.Clean surfaces thoroughly
3.Apply adhesion promoter
4. Peel liner and stick trim. (For large pieces, position and apply top half, and then proceed with the bottom half) Small pieces can be done at once
5. Press into position using a soft clean cloth.